2015 BMW X5 xDrive50iFACTORY OEM SERVICE PROCEDURE

11 61 Intake plenum

TIGHTENING TORQUE SPECIFICATION - INTAKE PLENUM

  Type Thread Tightening specifications Dimension
1AZ Suction module to cylinder head N63O1 M7x35   15 Nm
2AZ Charging pressure sensor to suction module N63O1 Ejot PT50x16   3.7 Nm
3AZ Hose clamp to charge air line N63O1 L83-90
L60-80
  3 Nm
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.