Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 BMW 740LiFACTORY OEM SERVICE PROCEDURE
Engine Electrical System - Repair (N55, 2013-)
- Safety And General Information
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- (11 00... Handling components after flood damage)
- 12 00... Instructions for removal and replacement of control units
- 12 00... Instructions for working on the ignition system
- 12 00... Notes/information on start assistance (jump starting)
- 12 00 Removing and installing/replacing ignition coil cover (N55)
- (61 00... Notes for disconnecting and connecting battery)
- (61 00... Notes on handling wiring harnesses and cables)
- (61 13... Opening contacts and locks of different plug contact systems)
- (61 13... Butt connector for repairing a plug connection)
- Spark Plugs
- Ignition Coils
- Electronic Switching Or Control Units
- 12 14 700 Encoding the control unit (DME)
- 12 14 705 Programming the control unit (DME)
- 12 14 600 Removing/replacing knock sensors (N55)
- 12 14 550 Replacing control unit (DME) (N55)
- 12 14 521 Replacing crankshaft pulse sensor (N55)
- 12 14 524 Replacing pulse sensor on exhaust camshaft (N55)
- 12 14 523 Replacing pulse sensor on intake camshaft (N55)
- 12 14 650 Replacing suction pressure sensor on intake plenum (N55)
- Alternator
- Starter
- Starter And Alternator Cables
- Engine Wiring Harness
- Oil Pressure Sensor, Oil Level Sensor
- Power Distribution Module
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
