Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2013128I 2D CONVERTIBLE, ENG CD N52, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 875 (GENERAL ELECTRICAL SYSTEM - REPAIR)31 SWITCH61 31 117 REMOVING AND INSTALLING/REPLACING POWER WINDOW SWITCH (DRIVER'S SIDE)
2013 BMW 128i 2D Convertible, Eng CD N52, Standard Trans
61 31 117 Removing And Installing/Replacing Power Window Switch (Driver's Side)
2013 BMW 128i 2D Convertible, Eng CD N52, Standard TransSECTION 61 31 117 Removing And Installing/Replacing Power Window Switch (Driver's Side)
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 317
Lever rocker switch (1) with special tool 00 9 317 upwards out of armrest.
Disconnect plug connection (1).
Installation:
Make sure retainers (2) are correctly seated on power window switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.