Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 BMW X5 MFACTORY OEM SERVICE PROCEDURE

52 26... Removing and installing/replacing FOLD microswitch

Necessary preliminary tasks

Remove backrest cover See 52 26 411 REPLACING BACKREST COVER FOR LEFT REAR SEAT or 52 26 412 REPLACING BACKREST COVER FOR RIGHT REAR SEAT .
Remove TRIMS FROM BACKREST FRAME, OUTER .

Fig 1: Uncliping Microswitch From Seat Backrest Frame
Courtesy of BMW OF NORTH AMERICA, INC.

Unclip microswitch (1) from seat backrest frame.

Installation:

Make sure contact sensor (2) is fitted correctly on pin (1).

Fig 2: Identifying Contact Sensor And Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten plug connection (1) and disconnect.

Fig 3: Identifying Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.