Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 BMW X1FACTORY OEM SERVICE PROCEDURE
Steering And Wheel Alignment - Repair
- Safety And General Information
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- 00 Safety instructions for handling oil
- 32... Overview of steering
- 32...... Overview of steering wheel/casing components
- 32 00... Identification of suspension without label
- 32 00... Description of front axle and wheel alignment
- 32 00 620 Adjusting rear axle
- 32 00 610 Adjusting toe-in and camber on front axle
- 61 31 996 Carrying out steering angle sensor adjustment
- 31 00... Front axle + steering repair work requiring subsequent wheel alignment (RWD)
- 31 00... Front axle + steering repair work requiring subsequent wheel alignment (AWD)
- (33 00... Rear axle repair work requiring subsequent wheel alignment)
- 32 00... Notes on replacement of steering gear/steering column/steering shaft following accident damage
- 32 00 155 KDS chassis/wheel alignment check with ride height measurement without vehicle load
- 32 00 150 KDS chassis/wheel alignment check with vehicle load up to design position
- 32 00... Moving vehicle into design position
- 32 00... Moving vehicle into normal position
- 32 00... Performing rim runout compensation
- 00..... Raising vehicle with trolley jack
- Mechanical Steering Gear
- 32 00... Notes on replacement of steering gear/steering column/steering shaft following accident damage
- 32 11... Notes on checking steering backlash on vehicles with rack-and-pinion steering (with front axle raised)
- 32 11 100 Replacing gaiter for steering box on left or right (AWD)
- 32 11 100 Replacing gaiter for steering gear on left or right
- Steering Gear With Servo Unit
- 32 10... Teaching in end stop software for electric steering gear (EPS)
- 32 00... Notes on replacement of steering gear/steering column/steering shaft following accident damage
- 32 13 006 Bleeding power steering unit
- 32 13 070 Removing and installing (replacing) electric steering box (EPS)
- 32 13 060 Removing and installing/replacing hydraulic steering gear
- 32 13 060 Removing and installing/replacing hydraulic steering gear (AWD)
- Steering Arms, Tie Rods, Steer. Damper
- Steering Column
- 32 31 020 Removing and installing/replacing lower section of steering column trim
- 32 31 082 Removing and installing/replacing steering angle sensor
- 32 31 090 Removing and installing/replacing steering column
- 32 31 070 Removing and installing/replacing steering spindle (in engine compartment)
- 32 31 003 Removing and installing/replacing upper section of steering column trim
- 32 31 090 Removing and refitting/replacing steering column
- 32 31 241 Replacing adjusting lever for steering column
- 32 31 102 Replacing steering spindle sleeve
- Steering Wheel
- Steering Wheel For Airbag
- Pump And Oil Supply
- (32 13 006 Bleeding power steering unit)
- 32 41... Instructions for removing and installing ear clips
- 32 41... Notes on hydraulic line with quick-connect coupling
- 32 41 060 Removing and installing (replacing) vane pump for hydraulic steering (N55)
- 32 41 060 Removing and installing (replacing) vane pump for power steering (N20)
- 32 41 100 Removing and installing/replacing belt pulley on vane pump for power steering
- 32 41 250 Removing and installing/replacing fluid reservoir for power steering
- 32 41 341 Replacing cooler return line for hydraulic steering (N55)
- 32 41 425 Replacing expandable hose part 1 for hydraulic steering (N20)
- 32 41 426 Replacing expandable hose part 2 for hydraulic steering (N20)
- 32 41 311 Replacing intake pipe for hydraulic steering (N55)
- 32 41 332 Replacing pressure line for power steering (N55 all-wheel drive vehicles)
- 32 41 341 Replacing radiator return hose for hydraulic steering (N20)
- 32 41 351 Replacing return line for hydraulic steering (N20)
- 32 41 351 Replacing return line for hydraulic steering (N55)
- 32 41 311 Replacing suction line for power steering
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
