2012 BMW 528iFACTORY OEM SERVICE PROCEDURE

34 52.. Start-Up Of ICM Control Unit

NOTE: Start-up of ICM control unit must be carried out:
  • After replacement or removal and installation of ICM control unit.

Connect vehicle to BMW diagnosis system.

Select and carry out start-up of ICM control unit under Service functions.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.