Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 BMW 528iFACTORY OEM SERVICE PROCEDURE
41 61... Check Hinge For Engine Compartment Lid
Necessary preliminary tasks:
- Remove hinge for engine compartment lid . See 41 61 071 REMOVING AND INSTALLING/REPLACING LEFT HINGE FOR ENGINE COMPARTMENT LID (ACTIVE PEDESTRIAN PROTECTION), VEHICLES UP TO 09/2011 or 41 61 071 REMOVING AND INSTALLING/REPLACING HINGE FOR ENGINE COMPARTMENT LID (ACTIVE PEDESTRIAN PROTECTION) VEHICLES FROM 09/2011
Open and close hinge (1).
Place hinge (1) on a level surface. Check holes (2) for parallelism with surface.
| Test result | Solution |
|---|---|
| Hinge is stiff | Replace hinge |
| Lack of parallelism | Replace hinge |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.