2012 BMW 528iFACTORY OEM SERVICE PROCEDURE

41 00... Blind Rivet

  1. 1.0 Recommended tools and equipment 
    • Blind riveting tongs
    • Rivet head extension

    Setting blind rivets: 

    • Refer to repair instructions for rivet size.
    • Position bore holes for blind rivets in accordance with specification in repair instructions. If necessary, carry over the positions of the blind rivets to the new part.
    • Drill holes that exceed the outer diameter of the blind rivet (example Ø 4.2 mm with 4 mm blind rivet and Ø 6.8 mm with 6.5 mm blind rivet).
    • The edge of the hole must even on both sides. If necessary, sand down and even out surfaces (e.g. edges of punch rivet connections). Deburr bore holes.
    • APPLY ADHESIVE .
    • Insert blind rivet. If necessary, remove adhesive that has emerged.

      Position blind rivet tool vertically. Use rivet head extension if accessibility is poor.

    • Rivet blind rivet with blind rivet tool. In the meantime clean rivet head if dirty with adhesive. Risk of damage to rivet head by penetrating adhesive.
    • Seal blind rivet with SEALANT D1  (risk of corrosion).
    • Seal cavities after work on vehicle paintwork on with CAVITY PRESERVATION  (risk of corrosion).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.