Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Control unit variants
Various electric fuel pumps can be operated with the fuel pump control module (EKPS). To do so, there are the following 2 control unit variants:
- Direct current (DC) version
- Rotary current (EC) version
With the direct current version, the electric fuel pump is driven by a direct current motor with permanent magnet. With the rotary current version, the electric fuel pump is driven by a brushless three-phase motor with permanent magnet. With the corresponding coding, it is possible to operate various fuel pumps with the relevant variant of the control unit. The two control unit versions are distinguished visually by the color of their connectors: The direct current variant has a maroon connector, the rotary current version has a white connector.
The fuel pump control module (EKPS) is continuously applied at terminal 30g_z (BN2000) or terminal 30B (BN2010) and when it is not active it requires only a very low standby current.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
