Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
52 26... Removing and installing/replacing FOLD microswitch
2011 BMW X5 MSECTION 52 26... Removing and installing/replacing FOLD microswitch
Necessary preliminary tasks
- Remove backrest cover See 52 26 411 REPLACING BACKREST COVER FOR LEFT REAR SEAT or 52 26 412 REPLACING BACKREST COVER FOR RIGHT REAR SEAT .
- Remove TRIMS FROM BACKREST FRAME, OUTER .
Unclip microswitch (1) from seat backrest frame.
Installation:
Make sure contact sensor (2) is fitted correctly on pin (1).
Unfasten plug connection (1) and disconnect.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.