SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011ALPINA B7REPAIR AND DIAGNOSISRESTRAINTSRESTRAINTS CONTROL SYSTEMSPASSIVE SAFETY SYSTEMS -- OVERVIEWSYSTEM FUNCTIONSSYSTEM MONITORING FUNCTIONSFAULT OUTPUT (DIAGNOSIS)
2011 BMW Alpina B7

Fault Output (Diagnosis)

2011 BMW Alpina B7SECTION Fault Output (Diagnosis)

With the aid of the ISTA diagnostic system, the fault memory can be read out via the diagnostic interface. After rectifying the faults or after replacing the triggered components, the fault memory can be cleared with the diagnosis command "Clear fault memory".

NOTE: The cleared fault code memory entries are transferred to the past events memory. A maximum of 15 faults can be stored in the past events memory. When another entry is added, the first entry is deleted. The past events memory is set up as a ring memory and can only be read out by the development department. The past events memory is not available to the Service department.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.