11 61 Intake plenum

2011 BMW Alpina B7SECTION 11 61 Intake plenum
TIGHTENING TORQUE SPECIFICATION - INTAKE PLENUM

  Type Thread Tightening specification Measure
1AZ Intake manifold to cylinder head N63 M7   15 Nm
2AZ Holder, intake module, to cylinder head N63 M6   10 Nm
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.