SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2011760LIREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 36 (COMPUTER RELEARN PROCEDURES)INTRODUCTIONSUN ROOF CALIBRATION3-SERIES
2011 BMW 760Li

Sun Roof Calibration: 3-Series

2011 BMW 760LiSECTION 3-Series
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2003 BMW Z8, 2003 BMW Z4, 2003 BMW X5, 2003 BMW M5, and 2003 BMW M3. However, it is still accessible from the selected car via links, so may be relevant.

Push sun roof button in up/tilt direction and hold. After about 20 seconds, sunroof panel will make a small down-up movement. Release button for no more than 5 seconds and push and hold it in up/tilt direction again. Sun roof will run through a full open and close cycle. Once this cycle is completed, initializaton and adaptation is complete.

NOTE: If motor runs in the wrong direction when pushing the button in the up/tilt direction, preventing proper initialization, get the sunroof to the closed position, and disconnect power to the motor for about 15 seconds. Reconnect the motor and start the initialization procedure again, and it should work properly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.