2011 BMW 535i GTFACTORY OEM SERVICE PROCEDURE

61 00... Program / encode the control unit (e)

NOTE:
  • In order to avoid incorrect programming procedures and fault messages, it is essential to always use the most current version when working with the ISTA/P programming system.
  • Battery voltage must not drop below 13.0 V  during programming. Connect battery charger prior to programming Use only BMW-recommended battery chargers*

programming routine via ISTA/P: 

  • Connect the battery charger to the vehicle.
  • Connect the programming system with the vehicle.
  • Determine the action plan and, if necessary, add complete car coding to the action plan.
  • Accept action plan with the control units to be programmed/encoded and enabled, if necessary or work through.
  • Observe the reworking list!
  • Connect the workshop system to the vehicle.
  • Perform brief test and delete fault memory.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.