Removal & Installation

2011 BMW 335is 2D Convertible, StandardSECTION Removal & Installation
WARNING: This page is about the 335is 2D Convertible, Automatic DCT, which is a different variant/trim than selected.
Applies ToNoteStandard HoursWarranty HoursSkill Level
6.8C
Combination Procedure: FLYWHEEL: Remove & Replace:
0.3C
Combination Procedure: FRONT PUMP &/OR SEAL: Replace:
1.3B
Combination Procedure: MAIN CONTROL VALVE BODY: Replace:
Includes: Programming.2.2B
Combination Procedure: REAR OIL SEAL OR DRIVE FLANGE: Remove & Replace:
0.8B
Combination Procedure: TRANSMISSION ASSEMBLY: Replace:
Includes: Programming.1.3C
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.