2011 BMW 335dFACTORY OEM SERVICE PROCEDURE

86 10... Replacing rear light

Release thumb screws (1), slide light guard (2) in direction of middle of car and tilt out towards rear.

Fig 1: Identifying Light Guard With Thumb Screws
G04766441Courtesy of BMW OF NORTH AMERICA, INC.

Turn handwheel (1) counterclockwise in direction of arrow and remove base (2).

Fig 2: Turning Handwheel
G04766442Courtesy of BMW OF NORTH AMERICA, INC.

Release nuts (1) and press rear light (2) out towards front.

Installation:Β 

Use new self-locking nuts.

Tightening Torque,Β 

refer to 86 10 1AZ

Fig 3: Identifying Rear Light With Nuts
G04766443Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.