Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 BMW X6 ActiveHybridFACTORY OEM SERVICE PROCEDURE
Terminal 15 (Wake-Up Line)
There are two lines for terminal 15 between the DDE control unit and CAS/FEM control unit:
- 15_WUP: This signal serves as a wake-up signal for the DDE control unit
- 15_3: Via this signal the CAS/FEM control unit can switch off the injector control of the DDE control unit in situations that are critical to safety
NOTE:
The following faults are monitored in the engine control unit: The signal transmission via the lines and the internal switches in the DDE control unit and in the CAS/FEM control unit are monitored by the DDE.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
