Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2010X5 30IREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE - REPAIR (N52)
2010 BMW X5 30i
Engine - Repair (N52)
2010 BMW X5 30iSECTION Engine - Repair (N52)
- Engine, General
- Cylinder Head And Cylinder Head Cover
- Oil Sump
- Housing Cover
- Crankshaft With Bearing
- Flywheel
- Vibration Damper
- Connecting Rod With Bearing
- Piston With Rings And Pin
- V-Ribbed Belt With TENSIONER / Deflect Element
- 11 28 050 Removing and installing/replacing drive belt for A/C compressor (N52K)(8FRU)
- 11 28 010 Replacing alternator drive belt (N51)
- 11 28 010 Replacing alternator drive belt (N52K)
- 11 28 020 Replacing tensioning device for alternator drive belt (N51)
- 11 28 020 Replacing tensioning device for alternator drive belt (N52K)
- Camshaft
- 11 31 005 Checking timing of camshaft(s) (N52K)
- 11 31 025 Removing and installing/replacing inlet camshaft (N52K)
- 11 31 028 Removing and installing/replacing exhaust camshaft (N52K)
- 11 31 051 Replacing timing chain (N52K)
- 11 31 090 Installing and removing/replacing chain tensioner piston (N52K)
- 11 31 505 Adjusting timing of camshaft(s) (N52K)
- Rocker Arm With Bearing Mount
- Valves With Springs
- Variable Camshaft Timing
- Variable Valve Gear
- Oil Supply
- Oil Pump With Filter And Drive
- Oil Filter And Lines
- Water Pump With Drive
- Thermostat And Connections
- Intake Manifold
- Exhaust Manifold
- Vacuum Pump
- Emission Control, Oxygen Sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.