2010 BMW 335dFACTORY OEM SERVICE PROCEDURE

Gateway Processor

The gateway processor converts all relevant data of the K-CAN system into MOST-bus telegrams and vice versa.

The electronic module is soldered into the board directly under the hard disk drive and cannot be replaced separately.

The gateway processor has its own control unit address in the BMW diagnosis system.

Fig 1: Identifying CIC System's Gateway Processor Location
G06895880Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.