Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
32 00... Test Conditions For Chassis/Wheel Alignment Check
2009 BMW X5 35dSECTION 32 00... Test Conditions For Chassis/Wheel Alignment Check
Observe the following test conditions prior to the chassis/wheel alignment check:
- Correct and identical rim and tire sizes.
- Correct tread depth. The tread depth for each axle may differ from left to right by max. 3-4 mm.
- Correct tire inflation pressure.
- Wheel bearing clearance OK
- Steering backlash OK
- Condition of suspension and shock absorbers OK
- Cars with ride level control: Pull fuse of air supply unit so that there is no controlling down or up.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.