2009 BMW X3 StandardFACTORY OEM SERVICE PROCEDURE

86 21 ... Adjusting Rear Lid To Fit

NOTE: The following text describes how to adjust the rear lid to fit at one mounting point as an example. Proceed in the same way for the other mounting points.

Height adjustment of rear lid:

Release screws (1) and move rear lid in direction of arrows.

Depth adjustment of rear lid:

Release screws (2) and move rear lid in direction of arrows.

Installation:Β 

Tightening Torque, height adjustment,

refer to 86 21 HOOD .

Tightening Torque, depth adjustment,

refer to 86 21 HOOD .

Fig 1: Identifying Rear Lid Screws
G04766454Courtesy of BMW OF NORTH AMERICA, INC.

Adjust gap (A) evenly all around without displacement and correct if necessary.

Fig 2: Identifying Rear Lid Gap
G04766455Courtesy of BMW OF NORTH AMERICA, INC.

Check lid in transition (B) to hood for displacement and correct if necessary (flush).

Fig 3: Identifying Lid In Transition To Hood
G04766456Courtesy of BMW OF NORTH AMERICA, INC.

To align lid in transverse direction, you can install or remove plastic washers (3) between hinge bracket (1) and mounting bracket (2).

Installation:Β 

There must always be a plastic washer (3) fitted on left and right sides of mounting bracket (2). Plastic washers are available in thicknesses of 1 mm and 3 mm.

Fig 4: Identifying Plastic Washer, Mounting Bracket & Hinge Bracket
G04766457Courtesy of BMW OF NORTH AMERICA, INC.

Check lid in transition (C) to hood (flush) and correct if necessary. Correction is made by inserting or omitting plastic washers (refer to Fig 4).

Fig 5: Identifying Lid In Transition To Hood
G04766458Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.