Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 BMW 335xi Sedan AWD (E90) L6-3.0L Turbo (N54)FACTORY OEM SERVICE PROCEDURE
Keyless Start Control Module: Service and Repair
61 35 950 - Removing and installing (replacing) control unit for comfort access system
Important!
Read and comply with notes on protection against electrostatic discharge (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).
Necessary preliminary tasks:
- Remove trim from rear apron 51 46 050 Removing and Installing/Replacing Top Trim on Rear Apron
- Remove right luggage compartment trim panel Removing and Installing/Replacing Right Luggage Compartment Wheel Arch Trim
- Partially detach insulating mat
Release screws (1) and pull back device holder (2).
Unfasten plug connection (1) and disconnect.
Unlock catch (2) in direction of arrow and remove control unit for comfort access system (3) upwards from device carrier (4).
Replacement:
Carry out programming/coding Programming and Relearning.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
