Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSBMW2008M5 (E60) V10-5.0L (S85)REPAIR AND DIAGNOSISSTARTING AND CHARGINGCHARGING SYSTEMALTERNATORTESTING AND INSPECTIONOSCILLOSCOPE PATTERNS AND WAVEFORMS
2008 BMW M5 (E60) V10-5.0L (S85)
Oscilloscope Patterns and Waveforms
2008 BMW M5 (E60) V10-5.0L (S85)SECTION Oscilloscope Patterns and Waveforms
Oscilloscope Target Image, Alternator
The following illustration represents the voltage progression of an intact generator. The level of the individual waves depends on the current load of the generator. The length of the waves depends on the engine speed. The higher the engine speed the shorter the waves.
At idle speed with consumer units switched on, an error-free generator should provide approximately this picture.
Waveform:
Examples of faulty generators are shown below.
The current as a function of engine speed also applies here.
Waveform:
Generator with defective diode
Waveform:
Generator with broken winding
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.