2007 BMW 525i AutomaticFACTORY OEM SERVICE PROCEDURE

11 .. .. Mounting engine on assembly stand (N52)

Special tools required: 

  • 00 1 450
  • 11 3 370
  • 11 4 440
  • 11 9 261
  • 11 9 265
IMPORTANT: Aluminium-magnesium materials. 

No steel screws/bolts may be used due to the threat of electrochemical corrosion.

A magnesium crankcase requires aluminium screws/bolts exclusively.

Aluminium screws/bolts must be replaced each time they are released. 

The end faces of aluminium screws/bolts are painted blue for the purposes of reliable identification.

Jointing torque and angle of rotation must be observed without fail (risk of damage  ).

Necessary preliminary tasks: 

Bolt engine or engine block with steel bolts (1) and aluminium bolts (2) to special tool 11 4 440.

To release central bolt, bolt on special tools 11 9 261 and 11 9 265 as well.

Mount engine with special tool 11 3 370 to special tool 00 1 450.

Fig 1: Identifying Special Tool (11 9 261), (11 9 265), (11 4 440),(00 1 450), Steel Bolts And Aluminium Bolts
G04725373Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.