2005 BMW 745LiFACTORY OEM SERVICE PROCEDURE

Transmission Control Module (EGS) Input/Output Signals Table

TRANSMISSION CONTROL MODULE (EGS) INPUT / OUTPUT SIGNALS REFERENCE

6HP Automatic Transmission
Input Signals Output Signals
CAS (Clamp Status) ECM (Status OBD-Error)
ECM (Engine Load 1, Brake-Pedal Switch) Pressure Regulator Valve, No. 1 ...5
ECM (Engine Load 2) Solenoid Valve, No. 1...4 (incl. Reserve)
ECM (Angle Accelerator Pedal, Engine Speed) Torque Converter Clutch Valve
SZL (Shift Lever Position)  
DSC (Wheel Speed)  
DSC (Status DSC, Brake Line-Pressure)  
Gear Range (Position "P" and "not P")  
Input Speed (Turbine)  
Output Speed  
Transmission Oil Temperature  
TRANSMISSION CONTROL MODULE (EGS) INPUT / OUTPUT SIGNALS REFERENCE

SMG Automated Manual Transmission
Input Output
Selector Lever: Line 0, 1, 2, 3, 4 Hydraulic Pump
Engine Speed  
Engine Torque  
Throttle Position  
Hydraulic Pressure  
Clutch Speed  
Rear Wheel Speed  
CAN Bus  
Shift Position  
Brake Signal  
Brake Light Switch  
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.