2005 BMW 745LiFACTORY OEM SERVICE PROCEDURE

Engine Control Module (ECM) Input/Output Signals Table

ENGINE CONTROL MODULE (ECM) INPUT / OUTPUT SIGNALS

Input Signals Output Signals
Transmission Control Module (EGS) (1) Transmission Control Module (EGS) (1)
Coolant Temperature Throttle Valve Actuator
Intake Air Temperature Ignition Coil
Mass Air Flow Injection Valve
Oxygen-Sensor Secondary Air Pump and Valve
Crankshaft Position/Speed Purge Valve (EVAP System)
Camshaft Position Switch Valve (Variable Camshaft Timing)
Throttle Position Malfunction Indicator Light (MIL)
Vehicle Speed Leak Diagnosis Module (EVAP System)
Knock Sensor Oxygen Sensor Heating
Leak Diagnosis Module (EVAP System) Valvetronic Control Module
Valvetronic Control Module Β 
(1) see tables below
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.