2005 BMW 745LiFACTORY OEM SERVICE PROCEDURE

Control Unit/Control Unit Connection

The MOST ring is composed of optical point-to-point connections between 2 control units. Each control unit has a network interface. The network interface consists of:

Fig 1: Identifying Control Unit/Control Unit Connection
G03390675Courtesy of BMW OF NORTH AMERICA, INC.
  • An opto-electrical converter (optical waveguide receiver, already mentioned).
  • An opto-electrical converter (optical waveguide transmitter, already mentioned).
  • A MOST transceiver (interface between the optical waveguide receiver/transmitter and the electronic network driver).
  • A network driver, the so-called NetServices.

The NetServices run on a microcontroller (main computer in the control unit)

On the application level, a control unit in the MOST framework contains stand-alone function units, so-called function blocks. Examples of function blocks include:

  • Tuners
  • Amplifiers
  • CD players

A control unit can contain several function blocks at one time, e.g. the AVT contains the functions:

  • Antenna
  • Amplifier
  • Tuner
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.