Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSBMW2004320I (E46) (CANADA) L6-2.2L M54REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSMAIN RELAY (COMPUTER/FUEL SYSTEM)SERVICE AND REPAIR
2004 BMW 320i (E46) (CANADA) L6-2.2L M54
Main Relay (Computer/Fuel System): Service and Repair
2004 BMW 320i (E46) (CANADA) L6-2.2L M54SECTION Service and Repair
Replacing Main Relay
Switch off ignition.
Connect DIS Tester.
Release screws (1).
Remove electronics box cover.
Installation:
Correctly install wiring harness with grommet in electronics box cover (water tightness).
Hook cover (3) into hinges of underside of electronics box (1).
Then correctly install upper stop (2) above hinges on underside of electronics box.
Arrangement:
1. Main relay of Digital Motor Electronics
2. Engine fuses of Digital Motor Electronics
Notes on troubleshooting:
If the starter motor cranks the engine during the starting sequence but the engine fails to fire, then:
1. Check engine fuses
2. If fuses are blown, replace them completely with fuse holder
3. Find out why fuses have blown
Continue troubleshooting as per DIS instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.