2003 BMW Z8 BaseFACTORY OEM SERVICE PROCEDURE

7-Series Service Maintenance Checklist

Condition Based Service (CBS) will determine which of the possible maintenance services listed below are required for a particular service visit.

Standard Operations

  • Brief diagnostic test.
  • Verify Check Control messages.
  • Check indicator and warning lights.
  • Reset CBS display.

Engine Oil

  • Change engine oil and oil filter. BMW recommends BMW High Performance 5W-30 synthetic oil (07 51 0 017 866).
  • After every fourth engine oil change, replace air cleaner filter.

Microfilter

  • Replace.

Front Brakes

  • Brake pads: replace. Clean brake pad contact points in calipers.
  • Brake discs: check surface and thickness.

Rear Brakes

  • Brake pads: replace. Clean brake pad contact points in calipers.
  • Brake discs: check surface and thickness.
  • Parking brake: check condition, brake lining thickness and function.

Vehicle Check

  • Check operation of horn, headlight flasher and hazard warning lights.
  • Check instrument and control lighting, and heater-A/C blower.
  • Check lighting system: turn signals, back-up, license plate, interior (inclding map reading lights), glovebox, flashlight, luggage area lights.
  • Safety belts: check condition and function.
  • Check windshield wiper and jet positions.
  • Body: check for corrosion.
  • Tires: check tread depth, wear pattern, outer condition, inflation pressure (including spare).
  • Battery: check state of charge ("magic eye") and recharge if required.
  • Power steering reservoir: check fluid level.
  • Visually inspect all SRS airbag units for torn covers, obvious damage or attachment of stickers.
  • Function of rear-view mirrors.
  • Coolant: check fluid level and concentration.
  • Windshield washer system: check fluid level and protection level.
  • Brake system connections and lines: check for leaks, damage and correct positioning.
  • Underbody: all visible parts including transmission, rear axle and fuel tank. Exhaust system: check for damage, leaks and corrosion.
  • Steering components: check for clearance, leaks, damage and wear.
  • Parking brake: check function.
  • Final Inspection: road test with check of brakes, steering, shock absorbers (external) and transmission.
  • Brake fluid: replace every 2 years.
  • Coolant: replace every 4 years.
  • Spark plugs: replace every 100,000 miles.
  • Automatic transmission: replace ATF every 100,000 miles.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.