2003 BMW Z4 2.5 3, AutomaticFACTORY OEM SERVICE PROCEDURE

Dynamic Driving Control (If Equipped): Notes

The MS45 ECM contains two different throttle progression functions (Sport and Normal). The Dynamic Driving Control function is selected by pressing the "Sport" button located in the center console (1).

The switch provides a ground signal (input) to the ECM when pressed. The MS45 activates the sport characteristics for the Electronic throttle control (EDK). This provides an increase in throttle opening and response time over the non-sport position.

Fig 1: Identifying Dynamic Driving Control Components
G03397627Courtesy of BMW OF NORTH AMERICA, INC.

When this function is activated, the function indicator light in the Sport button is illuminated by the Electric Power Steering (EPS) Control Module. When the ignition is cycled, this function resets back to the non-sport function (it must be re-selected by the driver).

The ECM additionally provides the request for the Dynamic Driving Control function over the PT CAN bus to the following control modules:

If equipped:

  • Electronic Power Steering (EPS)
  • Instrument cluster (Kombi)
  • Automatic transmission (EGS)
  • SMG 6-speed sequential manual gearbox
NOTE: Refer to the respective sections for the function influence on these systems.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.