2003 BMW M3 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Transmission Control System (GS 20): Notes

System is controlled by the GS 20 control module. The acronym (GS) comes from the German word "Getriebesteurung", meaning Gearbox Control. The design, program development and manufacturing of the GS 20 control system is the result of the combined efforts of BMW, Siemens and GM. The GS 20 control module is located in the E box in the engine compartment. See Fig 1 . It utilizes the 134 pin, "SKE" (standard shell construction), modular connector, enclosure. See Fig 2 , Fig 3 and Fig 4 .

Fig 1: Identifying GS 20 Control Module Location
G00317128Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.