Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Running Losses
The fuel circuit changeover (running losses) has not changed in operation from the previous system. The attached fuel pressure regulator no longer controls fuel pressure influenced by vacuum supply.
The ECM now determines the fuel quantity compensation for manifold vacuum changes. This is based on throttle position sensor, air mass meter, load, etc. for precise compensation.
The maintained fuel pressure at the fuel distribution rail is a constant 3.5 Bar.
The vacuum line no longer connects to intake manifold vacuum, but is routed to the crankcase cyclone separator (in case of regulator diaphragm leakage).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
