2003 BMW 760LiFACTORY OEM SERVICE PROCEDURE

11 00 045 Checking Absolute Compression Of All Cylinders

Diagnosis And Information System (DIS)Β 

Fig 1: Identifying Diagnosis And Information System Equipment
G03291774Courtesy of BMW OF NORTH AMERICA, INC.

Necessary Preliminary Tasks:Β 

  • Remove equipment wall.
  • Remove spark plug from 8th cylinder.

    (Without removing manifold).

  • Connect DIS Tester.
  • Connect charger.

Test:Β 

  • Call up Diagnosis.
  • Select vehicle > right arrow button.
  • Function selection:
    • Complete vehicle.
    • Drive.
    • Engine management:
      • Valve gear.
      • Valvetronic variable valve gear.
      • Mechanical components/function.
  • Test schedule > right arrow button.
    • Compression pressure check > right arrow button.
  • Follow DIS Tester instructions.
NOTE: Clear fault memory. A mechanical compression pressure check is not possible.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.