2003 BMW 745LiFACTORY OEM SERVICE PROCEDURE

Self-Diagnosis During Operation

During operation, the SIM continuously monitors itself. If a fault is found, the byteflight  communication is stopped and the power supply of the satellites is switched off by the SIM. (See WATCHDOG FUNCTION  )

The S/E modules are capable of diagnosing the optical signal quality. A warning signal is generated when the optical reception quality falls below a certain threshold. The communication still can function without faults.

The SIM and all the satellites continuously check the VIN received across the byteflight  against the VIN entered in the control units. If there is no match or an entry is missing, the AWL is switched on.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.