2003 BMW 745LiFACTORY OEM SERVICE PROCEDURE

Control Module Testing

  • Next you are instructed to attach the MOST control unit cable P/N 663 122 (2) and the MOST test loop P/N 663 124 (4).

    This is a crucial step and must not be ignored. Failure to complete this step will result in incorrect readings and results.

  • Remove the test loop
    Fig 1: Attaching Most Control Unit Cable P/N 663 122 And Most Test Loop P/N 663 124
    G03396820Courtesy of BMW OF NORTH AMERICA, INC.
  • Remove the SVS harness from the module
  • Remove the fiber optical insert (4) from the SVS harness plug.
  • Insert the free end of the MOST CM cable P/N 663 122 (5) into the SVS harness plug and plug the assembly into the SVS module.
  • Follow the DISplus/GT1 test module instructions.
    Fig 2: Inserting Free End Of Most CM Cable P/N 663 122 Into SVS Harness Plug
    G03396821Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.