2003 BMW 745LiFACTORY OEM SERVICE PROCEDURE

Control Module Harness Testing

  • Remove the test loop.
  • Remove the SVS harness (6) from the module
    Fig 1: Removing SVS Harness From Module
    G03396822Courtesy of BMW OF NORTH AMERICA, INC.
  • Remove the fiber optical insert (2) from the SVS harness plug (1)
    Fig 2: Removing Fiber Optical Insert From SVS Harness Plug
    G03396823Courtesy of BMW OF NORTH AMERICA, INC.
  • Plug a MOST attachment housing P/N 663 125
    Fig 3: Locating MOST Attachment Housing P/N 663 125
    G03396824Courtesy of BMW OF NORTH AMERICA, INC.
  • Into the MOST wiring harness
    Fig 4: Identifying MOST Wiring Harness
    G03396825Courtesy of BMW OF NORTH AMERICA, INC.
  • Plug the free end of the MOST wiring extension cable into the MOST attachment housing.
  • Follow the DISplus/GT1 test module instructions
    Fig 5: Inserting Free End Of MOST Wiring Extension Cable Into MOST Attachment Housing
    G03396826Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.