Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Remove and Install Engine Cover
E60, E61 only:
To remove cover of fuel injectors: Necessary preliminary tasks: Remove microfilter housing lower sections on left and right. Unclip wiring harness sections (1) from cable holder (3). Lever out expansion rivets (2). Remove cable holder (3) from tension struts in direction of arrow.
All models:
Unclip cover caps from screws and release screws. Remove cover for fuel injectors.
Unclip cover caps from screws and release screws. Remove sealing cap (1). Remove cover from ignition coil cover. Screw cap (1) back into cylinder head cover.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.