Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
13 00 002 Checking Function Of Digital Engine Electronics (DME)
Diagnostic Connector In Engine Compartment:
Connect up MoDiC or BMW DIS.
Interrogate DME fault memory.
Note down fault messages stored in memory.
Further information on troubleshooting in line with DIS or MoDiC instructions.
OBD Socket (1) In Driver's Footwell:
Same procedure as above.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.