2002 BMW M3 2D ConvertibleFACTORY OEM SERVICE PROCEDURE

Mk-3 Navigation Computer

The Mk-3 navigation computer is located in the left side of the vehicles trunk or cargo area.

(In the case of the Z8 it is installed in the storage box behind the passenger seat.)

The navigation computer housing contains:

  • Map CD Drive
  • Hardware For Navigation Function
  • GPS Receiver
  • Gyro Sensor
  • Output For Audio Interface
  • Output For Visual Display
  • Cooling Fan For Unit
Fig 1: Locating Mk-3 Navigation Computer
G03395682Courtesy of BMW OF NORTH AMERICA, INC.

There are two different hardware versions available dependent on the angle of installation in the vehicle (horizontal or vertical). The Mk-3 is compatible with both board monitor or MIR display units. (See workshop hints for configuration instructions).Β 

Identification of the Mk-3 computer over the previous versions is easy due to a change in the face plate design and the elimination of the "CD-IN" LED.

Fig 2: Identifying Mk-3 Navigation Computers
G03395683Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.