Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 BMW X5FACTORY OEM SERVICE PROCEDURE
Power Window System
The power window operation on the X5 is similar to previous systems. Features of the system include:
- Control of the front and rear door window motors is carried out directly by the General Module (GM).
- One-touch operation in both directions on all 4 windows.
- Cable type window regulator used for all windows.
- Anti-trap detection is provided by the pressure sensitive finger guard.
- Push/pull window switches.
- The rear window switches located in the rear doors can be deactivated by pressing child lock out switch in the center console.
- Convenience closing/opening of the windows from the driver's lock cylinder or convenience opening only from the FZV (central lock receiver) remote key (FZV operation can be owner customized with the car memory function).
- Window operation with the ignition switched off until a door is opened or 16 minutes has elapsed after the key is switched off.
- Window load switching is through relays integral of the GM for rear windows and in the respective door switch block modules for the front windows.
- The current draw is monitored for end limit position.
- The maximum run time for the window motors is limited to 8 seconds, allowing motors to be switched off if the end limit load sensing fails.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
