Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 BMW M5FACTORY OEM SERVICE PROCEDURE
Rear (E52)
NOTE:
Any change in camber always involves a change in toe. The camber must always be adjusted first. See REAR (E52) under CAMBER ADJUSTMENT.
- Replace and tighten down disk collar nut. See Fig 1.
- Tighten disk collar nut to specification. See E52 under TORQUE SPECIFICATIONS.
- Release disk collar nut again by 1/2 to 1 turn.
- Adjust toe-in with eccentric screw. See Fig 2. Adjust to specification. See E52 under WHEEL ALIGNMENT SPECIFICATIONS.
- Tighten down disk collar nut to specification. See E52 under TORQUE SPECIFICATIONS.
CAUTION:
If the disk collar nut is tightened down more than 10 times during adjustment, it must be replaced. The self-locking effect becomes too slight.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.