Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 BMW 528i StandardFACTORY OEM SERVICE PROCEDURE
IHKA Climate Control System (E39): Introduction: Components
The major components of the IHKA E39 heater case include:
- Two heater cores with separate inlets and one common outlet.
- Two heater core temperature sensors and one evaporator temperature sensor.
- One evaporator with expansion valve.
- Five stepper motors (six as of 9/97) - four on the M-Bus link and one conventionally controlled.
- One auxiliary water pump.
- One blower motor and relay with final stage output control (final stage located in air flow on passenger side of IHKA housing).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
