1997 BMW 528i AutomaticFACTORY OEM SERVICE PROCEDURE

IHKA Climate Control System (E39): Introduction: Components

The major components of the IHKA E39 heater case include:

  • Two heater cores with separate inlets and one common outlet.
  • Two heater core temperature sensors and one evaporator temperature sensor.
  • One evaporator with expansion valve.
  • Five stepper motors (six as of 9/97) - four on the M-Bus link and one conventionally controlled.
  • One auxiliary water pump.
  • One blower motor and relay with final stage output control (final stage located in air flow on passenger side of IHKA housing).
    Fig 1: Identifying Components Of IHKA E39
    G03389562Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.