1997 BMW 328is AutomaticFACTORY OEM SERVICE PROCEDURE

Starter Specifications

STARTER SPECIFICATIONS

Application Specification
Axial Armature Play .1-.2 mm
Brush Length 13 mm (minimum)
Testing Voltage 11.7-12.3 Volts
Rated Power
M50, M52, S52 1.7 kW
M51 2.2 kW
M60, M62 1.7 kW
M70, M73 2.2 kW
M57 2.2 kW
M67 2.6 kW
S62 1.7 kW
Current Consumption At Terminal 50 (Rated Power Of 1.4 kW)
Pull-In Winding 54.5 A
Hold-In Winding 10.5 A
Current Consumption At Terminal 50 (Rated Power Of 1.7 kW with Intermediate Transmission)
Pull-In Winding 51 A
Hold-In Winding 9.5 A
Current Consumption At Terminal 50 (Rated Power Of 1.8 kW)
Pull-In Winding 50 A
Hold-In Winding 12 A
Current Consumption At Terminal 50 (Rated Power Of 2.0 kW)
Pull-In Winding 54.5 A
Hold-In Winding 10.5 A
Current Consumption At Terminal 50 (Rated Power Of 2.2 kW)
Pull-In Winding 58 A
Hold-In Winding 13 A
Current Consumption At Terminal 50 (Rated Power Of 2.2 kW with Intermediate Transmission)
Pull-In Winding 60 A
Hold-In Winding 10 A
Current Consumption At Terminal 50 (Rated Power Of 2.6 kW with Intermediate Transmission)
Pull-In Winding 50 A
Hold-In Winding 12 A
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.