1996 BMW Z3 AutomaticFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS

Component Component Location
Anti-Theft Control Module (Alpine) Behind glove compartment.
Central Locking Module Behind glove compartment. See Figure.
Chime Module Below left side of dash.
Crash Control Module On relay panel, under left side of dash. See Figure.
Cruise Control Module Under right side of dash, behind glove compartment. See Figure.
Electronic Immobilizer Control Module (EWS II) Under right side of dash, behind glove compartment. See Figure.
Engine Control Module Rear right side of engine compartment, in E-box.
Slip Control Module (ABS) Under right side of dash, behind glove compartment. See Figure.
Slip Control Module (ABS/ASC) Under right side of dash, behind glove compartment. See Figure.
Supplemental Restraint System Control Module Below center console.
Transmission Control Module Right rear side of engine compartment, in E-box.
Wiper/Washer Module (Low II) Behind glove compartment. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.