Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 BMW 328is StandardFACTORY OEM SERVICE PROCEDURE
Torque Specifications
STARTER AND MOUNTING PARTS
| Type | Thread | Measure | |
| Starter motor mounting to transmission bell housing | All, except N51, N52, N52K, N53, N54 | 45 Nm | |
| Support to starter | All | M5 | 5 Nm |
| Support to crankcase | All | 47 Nm | |
| Electrical leads to starter | |||
| All | M5 | 5 Nm | |
| All | M6 | 7 Nm | |
| All | M8 | 13 Nm | |
| Bolt connection, pole tube | All | M6 | 6 Nm |
| Heat shield to starter motor | M6 | 6 Nm | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.