Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1995 BMW 850CSiFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application

Preferred

Range

Camber ⁽¹⁾

Front

-.22

-.72 To .17

Rear

-1.5

-1.83 To -1.27

Caster ⁽¹⁾

6.1

5.6 To 6.6

Toe-In ⁽²⁾

Front

.11

.07 To .15

Rear

.15

.07 To .23

Toe-In ⁽¹⁾

Front

.23

.15 To .31

Rear

.30

.13 To .47

Toe-Out On Turns ⁽¹⁾

Inner

*****

Outer

*****

Steering Axis

Inclination ⁽¹⁾

*****

⁽¹⁾	Measurement in degrees.

⁽²⁾	Measurement in inches.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.