Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 BMW 850CSiFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Adjusting Screw Lock Nut | 20 (27) | |
| Flow Control Regulator Hose Connections | 30 (40) | |
| Power Steering Pump Cover | 12-14 (16-19) | |
| Sector Shaft End Cover | 16 (22) | |
| Steering Gear/Steering Pump Hose Connections | ||
| M14 Bolts | 26 (35) | |
| M16 Bolts | 30 (40) | |
| Steering Gear-To-Front Axle | ||
| M10 Bolts | 31 (42) | |
| M12 Bolts | 59 (80) | |
| Steering Pump Mounting | 16 (22) | |
| Worm End Cover | 25 (34) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.