1995 BMW 325is AutomaticFACTORY OEM SERVICE PROCEDURE

Relays & Solenoids: Relays

For fuel pump relay, see FUEL DELIVERYΒ  under FUEL SYSTEM. Additional information is not available from manufacturer. For relay locations, see DME/MOTRONIC SYSTEM RELAYS LOCATION table.

DME/MOTRONIC SYSTEM RELAYS LOCATION

Application (1) Location
325i, 325iC, 325is (2) Behind Cover, Along Engine Compartment Firewall
525i & 525iT (2) Right Inner Fender Panel Of Engine Compartment
(1) See Fig 1 .
(2) First relay (viewed from left to right) after ground wire is fuel pump relay followed by Digital Motor Electronics (DME) master relay.
Fig 1: Locating DME/Motronic System Relays - 1 Of 2 (325i, 325iC, 325is)
G94E46056Courtesy of BMW OF NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.