1994 BMW 740iFACTORY OEM SERVICE PROCEDURE

ASC Regulation

When the Slip Control Module (ASC+T) detects excessive wheel slip due to acceleration, it signals the Auxiliary Throttle Control Module (ADS II) via a pulse-width modulated signal as to the necessary amount of power reduction required. The Auxiliary Throttle Control Module (ADS II) then activates the ADS II actuator. The ADS II actuator closes the choke valve plate via a bowden cable (similar to cruise control actuator operation) and thereby reduces engine power. If additional regulation is required, the Slip Control Module (ASC+T) can also signal the Engine Control Module (DME), which can then retard ignition timing to further reduce engine power. Further traction control at the rear wheels can be achieved via brake application by the ASC+T hydraulic unit.

ASC+T has the function of shift intervention (i.e. no shifting via Electronic Transmission Control (EGS) during ASC regulation).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.